This case is similar to Canon's previous generation, which had its full effect asked the count is reset in the bios eeprom canon. For the case of MP258 Error 5b00 or P07.
Early indications:
When the MP287 is turned on, it will immediately appear on the LCD panel error E08 MP287. And when we do print command, then the monitor screen will show "The Ink Absorber is Almost Full".
How to Reset MP287 Canon E08 error
- Turn on the Canon MP287, MP287 LCD then the panel will pop up error E08, and there is a description of "The Ink Absorber is Almost Full" on the screen of your monitor.
- Download Resetter MP287 at THIS LINK. You will be redirected to the ad first, then click SKIP ADS / skip.
- Canon MP287 printer must be in a state of SERVICE MODE. Do I read the next step.
- Canon MP287 Turn off the E08 error by pressing the power. Do not unplug the power cord
- Press and Hold the button STOP / RESET followed by pressing the POWER button. So both buttons depressed position.
- Release the button STOP / RESET but do not release the button POWER.
- In these circumstances the POWER button is still depressed, press the STOP / RESET 6 times.
- Then release both buttons simultaneously. Then the Canon MP287 will be in Service Mode condition.
- LCD Panel MP287 will blank / dark and in your computer will detect new hardware. Ignore it ...
- You still with ekohasan blog, the next step Exctract and Run Service Tool for MP287 MP287 E08 error you downloaded earlier.
- Click the "PLAY", then the printer will proceed, then MP258 will print one page with the words "D = 000.0"
- Click "Clear EEPROM".
- Then click "EEPROM", and the printer will print the results MP258 Resetter. Writing one line as follows: "TPage (COPY TTL = 00 000 = 00 000)"
- Turn off Canon MP287 by pressing the power.
- Canon MP287 printer that error E08 will be normal again
Good luck.
where is the LINK?
ReplyDelete